Important Safety Instructions; Installation; Rackmount Installation - Tripp-Lite PDU2430 Manual Del Propietário

Important Safety Instructions

This manual contains information concerning the proper installation
and use of Tripp Lite's Rackmount Power Strips.
SAVE THESE INSTRUCTIONS.
Do not connect your power strip to an ungrounded outlet. Do not use it with extension
cords or adapters that eliminate its connection to ground. Your power strip is designed
for indoor use only. Install it away from heat emitting devices such as radiators and
heat registers. Do not install where excessive moisture or other conductive
contaminants are present. Never install electrical wiring during a lightning storm.

Installation

1U Rackmount
Installation
To Mount Unit in Rack: Put four user-
supplied rackmount screws (A) through the
unit's mounting ears (B) and into the rack
rails as shown. The user must determine
the fitness of the rackmount screws to
hold the unit in the rack before
installation.
0U Rackmount
Installation
1. Reorient Mounting Ears: Unscrew the
screws (A) holding the unit's mounting
ears (B) to the sides of the unit. Use
the screws from Step 1 (A) to reattach
the mounting ears (B) to the unit as
shown. Use only the manufacturer-
supplied screws or their equivalent (#6-
32, ¼" flat head) to reattach the
mounting ears.
2. Mount Unit on Outside of Rack Rails: Put four user-supplied screws (C) or similar mounting
hardware through the unit's mounting ears (B) and into the side of the rack as shown. The user
must determine the fitness of the user-supplied mounting hardware to support the unit before
mounting.
Wallmount/Under Counter Installation
Reorient the unit's mounting ears as per the 0U Rackmount Installation above, then put four user-
supplied screws or similar mounting hardware through the unit's mounting ears and into the
mounting surface. The user must determine the fitness of the user-supplied mounting hardware to
support the unit before mounting.
14-02-328-932173.indb 2
1U Rackmount Installation
2
0U Rackmount Installation
3/25/2014 3:08:40 PM