Maintenance; General; Carburetor; Muffler - Husqvarna 350BT Manual De Instrucciones

Ocultar thumbs Ver también para 350BT:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

General

Remove the ignition cable and the spark plug to carry out
inspection and maintenance. Keep all parts of your body
away from hot surfaces.

Carburetor

Adjustment of the idle speed
Before any adjustments are made, make sure that the air
filter is clean and the air filter cover is fitted.
350BT
The factory idle speed setting is: 2200 rpm.
530BT
The factory idle speed setting is: 3000 rpm.
Use the adjustment screw at the upper edge of the
carburettor if the idle speed has to be adjusted.
Muffler
The muffler is designed to reduce the noise level and to
direct the exhaust gases away from the operator. The
exhaust gases are hot and can contain sparks, which may
cause fire if directed against dry and combustible
material.
The muffler is equipped with a special spark arrestor
screen. The spark arrestor screen should be cleaned
once a month. This is best done with a wire brush.
(4)
(3)
(5)
(5)
530BT
To remove the spark arrestor screen proceed as follows:
Remove the exhaust duct (4, 5).
Remove the spark arrester (3).
Pull out the spark arrestor screen and clean using a
wire brush. Replace the spark arrestor screen if it is
defective.
Remove any carbon deposits in the muffler's inlet and
outlet and in the cylinder's exhaust port.
18 – English

MAINTENANCE

(3)
(4)
350BT,BF
CAUTION! Never use a machine with a defective muffler.
Check regularly that the muffler is complete and secured
correctly. Tighten the screws.
350BT 8-12 Nm. (1)
530BT 7-11 Nm. (2)
530BT
Check that the spark arrester and the exhaust duct are
screwed in place correctly (5). Tighten to 2-3 Nm.
WARNING! The muffler gets very hot
!
during use and remain so for some time
after stopping. This also applies at idle
speed. Contact can result in burns to the
skin. Remember the risk of fire!

Cooling system

To keep the working temperature as low as possible the
machine is equipped with a cooling system.
The cooling system consists of:
Cooling fins on the cylinder.
Air intake screen
Clean the cooling system with a brush once a week, more
often in demanding conditions. A dirty or blocked cooling
system results in the machine overheating which causes
damage to the piston and cylinder. Check that the nozzles
are not blocked.
1155685-49 Rev. 3 2014-11-29
(1)
(2)
(1)
350BT,BF

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

350bf530bt180 bt

Tabla de contenido