Publicidad
Idiomas disponibles
Idiomas disponibles
1. ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there:
The assistance of a second person is
required for assembling this machine.
Fig.1; Box 1.-
(A)
Main body
(B)
Outer left stabiliser
(C)
Outer right stabiliser
(D)
Main post
(E)
Weight columns;
(F)
Vertical mast
(G)
Front right side panel
(H)
Rear left side panel
(I)
Rear right side panel
(J)
Front left side panel
(K)
Top body
(L)
Seat support
(LL) Leg support
(34) Seat
(48)
Backrest
(N)
Weight selector post
(98) Arm limit plate
(95) Bottom mast brace
(M)
Long exercise bar
(51) Top cover
(N)
Short exercise bar
(O)
Butterfly bars
(65) Leg support adjustment knob
(29) Seat locking pin
(P)
Weight selector.
(Q)
Butterfly exercise selector
(26) Weight buffer springs
(32) Weight buffer washers.
(69) Handgrip strap
(65) Long foam covers
(66) Top leg support foam cover
(67) Bottom leg support foam cover
(43) Main body trim covers
(44) Foam covers
(96) Support plate
English
NUTS & BOLTS
(85) Bolts M-6x20.
(97) Bolts M-6x12.
(91) Flat washers M-6.
(86) Bolts M-6x8.
(83) Bolts M-8x15.
(90) Flat washers M-8
Double ended ring spanner
Box spanner
Fig.1; Box 2.-
(48) Top weight.
(50) Weight set.
1.-Place
horizontal position (lying flat) on a
table or other level surface Fig.2.
2.-Place the bases (B-C) onto the
main body (A), as shown in Fig.2A,
ensuring the stickers on the left and
right match up, and tighten the screws
(83).
3.-Release the bolts and the rear plate
(87). Fit the support leg (D) tightening
the bolts against the rear plate (87)
Fig.3.
4.-Put the screws (95) into the screw
holes so that they are in their correct
position, without tightening Fig.4A.
Make sure the main structure (F)
remains in a vertical position Fig.4.
5.-Fit the top body (K) Fig.5 onto the
main body (A), inserting the tip of the
cable through the hole (M). Hand
tighten the nuts as shown in Fig.5A.
18
the
main
frame (A)
in
Publicidad
