Fein WSG10-115 Instrucciones De Uso página 19

3 41 01 117 21 0.book Seite 19 Dienstag, 13. September 2011 8:13 08
Mounting a grinding disc (Figure 6) WSS14-125.
Loosen the quick-clamping lever and
swivel it to the stop.
Completely unscrew the clamping unit
by hand.
Change the used accessory or insert a
new one.
Turn the clamping unit in when the
quick-clamping lever is open. Manually
tighten the clamping unit a ratcheting
noise starts.
Swivel the quick-clamping lever back
until it engages.
Adjustments.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Adjusting the guard (Figure 7)
WSG10-115/WSS14-125/WSG14-125.
Unclamp the clamping lever.
Swivel the guard into the required
working position.
Notch in the clamping lever.
Fig. 7
Clamping lever
Wheel guard
Fig. 6
Clamping unit
Quick-clamping lever
en
19