Fein WSG10-115 Instrucciones De Uso página 20

3 41 01 117 21 0.book Seite 20 Dienstag, 13. September 2011 8:13 08
en
20
Adjusting the guard (Figure 8)
WSG10-125S/WSG14-125S/
WSG14-150/WSG14-70E.
Loosen the tightening screw.
Turn the wheel guard to the required
working position and clamp the wheel
guard using the
clamping
Working instructions.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching ON and OFF (Figure 9).
First check that the power
WARNING
cable and power plug are not
damaged.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power
tool.
The self-start lock prevents the angle grinder
from automatically restarting again, even after
a brief interruption of the power supply, e.g.,
from a pulled mains plug.
:
Switching ON
Push the switch towards the front (I).
:
Switching OFF
Press the switch downward (0).
Fig. 8
screw.
Clamping screw
Fig. 9
Wheel guard
On/Off switch