Working With Robots - jbc DDSE-A Serie Manual Del Usuario

Working with Robots

Manage and monitor the station using a Robotic system.
1. Connect the tool to the station port by means of the Converter.
2. Connect your Robot system to the Robot connector (RJ12) of the station.
DB9-RJ12 Adapater available only if necessary (Ref: 0013772).
3. Enable the Robot option in the station settings and the notification will be displayed:
4. Set your Robot's commands according to the Robot Communication Protocol, available on the
website www.jbctools.com/jbcsoftware-menu-115.html.
Robot
Update the station software
1. Download the JBC Update file from
www.jbctools.com/software.html and
save it on a USB flash drive. Preferably
one with no other files.
JBC
Update file
18
Converter
Ref. 0002747
Control
Unit
RS-232
connection
2. Insert the USB flash drive.
The icon is diplayed while updating.
Maintenance
Before carrying out maintenance or storage, always allow the equipment to cool.
- Clean the station screen with a glass cleaner
or a damp cloth.
- Use a damp cloth to clean the casing and
the tool. Alcohol can only be used to clean
the metal parts.
- Periodically check that the metal parts of
the tool and stand are clean so that the
station can detect the tool status.
- Maintain tip surface clean and tinned prior
to storage in order to avoid tip oxidation.
Rusty and dirty surfaces reduce heat
transfer to the solder joint.
- Periodically check all cables and tubes.
- Replace a blown fuse as follows:
Fuse holder
1. Pull off the fuse holder and remove the
fuse. If necessary use a tool to lever it off.
- Replace any defective or damaged pieces. Use original JBC spare parts only.
- Repairs should only be performed by a JBC authorized technical service.
w w w.jbctools.com
Clean periodically
Fuse
Fuse holder
2. Press the new fuse into the fuse holder
and replace it in the station.
19