4
POSITION TEMPLATE
14
To calculate your precise wall plate location, check out
TIP:
our HeightFinder at sanus.com [www.sanus.com/1172].
14
Place the wall plate template
slotted holes over your stud center lines. Level and mark the hole locations.
Visit
HeightFinder™
sanus.com
/1172
at your desired height and position the
5
DRILL
4X
14
CAUTION:
Be sure you drill into the CENTER of the stud.
Drill the four pilot holes using a 3/16 in. (5 mm) diameter drill bit.
IMPORTANT: Pilot holes must be drilled to a depth of 2 ¾ in. (7.0 cm).
2 ¾ in. (7.0 cm)
3/16 in.
(5 mm)
16
11