Página 1
THANK YOU FOR CHOOSING SANUS THE #1 TV MOUNT BRAND IN THE US. BLF 125 Instruction Manual Scan for easy install video...
Página 2
TWO SIMPLE STEPS TO FINDING YOUR STUDS: Holding it vertically, lightly move the SANUS Pull apart the SANUS Magnetic Stud Finder to Step 1 Step 2 Magnetic Stud Finder up and down while expose the probing pin within.
Página 3
BLF125 We’ll Make It Stress-Free If you have any questions along the way, just give us a call. 1-800-359-5520 (UK: 0800-056-2853) We’re ready to help! Lo haremos sin estrés Si tiene preguntas mientras realiza la instalación, llámenos. 1-800-359-5520 (Reino Unido: 0800-056-2853) Estamos listos para ayudarlo.
Página 4
Does your TV weigh No — Perfect! (including accessories) 125 lb more than 125 lbs. Yes — This mount is NOT compatible. Visit MountFinder.Sanus.com or call (56.7 kg) 1-800-359-5520 (UK: 0800-056-2853) to fi nd a compatible mount. (56.7 kg)? What is your...
Página 5
Attach Bracket to TV STEP 1 Parts and Hardware for STEP 1 WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer;...
Página 6
1.1 Select TV Screws 1.2 Spacers Hand thread screws into the threaded inserts on the back of your TV Spacers and screws are supplied to install your TV bracket. to determine which screw diameter (M4, M5, M6, or M8) to use. Determine your preference for spacer configuration when attaching your TV bracket.
Página 7
1.3 Attach TV Brackets Slide TV bracket plate into upper TV bracket and loosely install using two thumb screws Slide the upper and lower TV brackets onto the ends of the vertical TV bracket...
Página 8
Position the TV bracket assembly over your TV hole pattern, center horizontally and If your TV included inset spacers or loosely install using the spacer, TV screw and washer combination (a) or (b) you wall mount adapters, selected for your TV. see Troubleshooting CAUTION: Avoid potential personal injury or property damage! The TV Bracket...
Página 9
Vertically center TV bracket Visually line up the locator hole in the lower TV bracket , with a hole in the vertical TV bracket and install using two thumb screws . Tighten the four thumb screws on the upper and lower TV brackets.
Página 10
Tighten the four TV screws (PAGE 8) on the upper and lower TV brackets. CAUTION: Avoid potential personal injuries and property damage! DO NOT use a power screwdriver for this step. Tighten screws only until TV Bracket is secured in place. DO NOT overtighten M4 screws TV Screws...
Página 11
13 cm (5 in.) between your device and the magnet. Please consult with your physician or medical professional prior to using this product. NOTE: Not all hardware included will be used. Sanus Magnetic Stud Finder * Wall Plate...
Página 12
Stud centers must be verified – not all walls have conventional 16 in. (406 mm) or 24 in. (610 mm) stud spacing Locate a nail/screw in the studs using the Sanus magnetic stud finder provided. Find the edges of the studs using the...
Página 13
Level the wall plate template and tape in place. NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com. IMPORTANT : Be sure you mark and drill into the center of the stud.
Página 14
Remove the wall plate template Slide the covers open on the wall plate to expose the mounting holes.
Página 15
Install the four lag bolts . Firmly tighten all four lag bolts until they are pulled flush against the wall plate NOTE: Hold the wall plate in place when tightening the first lag bolt to keep the plate from shifting out of place. CAUTION: Avoid potential personal injury or property damage! All four lag bolts MUST BE firmly tightened to prevent unwanted...
Página 16
Level the wall plate template and mark the hole locations. NOTE: For assistance in determining wall plate location, see Height Finder at sanus.com. Drill four pilot holes using a 3/8 in. (10 mm) diameter drill bit.
Página 17
Remove the wall plate template and insert four anchors CAUTION: Be sure the anchors are seated flush with the concrete surface. Slide the covers open on the wall plate to expose the mounting holes.
Página 18
Install the four lag bolts . Firmly tighten all four lag bolts until they are pulled flush against the wall plate NOTE: Hold the wall plate in place when tightening the first lag bolt to keep the plate from shifting out of place. CAUTION: Avoid potential personal injury or property damage! All four lag bolts MUST BE firmly tightened to prevent unwanted...
Página 19
STEP 3 Attach TV to Wall Plate Part for STEP 3 WARNING: Before starting assembly, verify this part is undamaged. If damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! Arm Assembly...
Página 20
3.1 Attach Arm Assembly to Wall Plate CAUTION: Avoid potential personal injury or property damage! The arm assembly MUST BE installed with the lock lever oriented on the bottom as shown. Slide the lock lever to the unlock position. Unlock Lock...
Página 21
HEAVY ! You may need assistance with this step. Hang the top hook , of arm assembly , onto wall plate , then rest the arm assembly into place until you hear the lock click, securing the arm in place.
Página 22
CAUTION: Avoid potential personal injury or property damage! For concrete applications, the arm assembly must remain centered in the wall plate NOTE: For wood stud applications, the arm assembly can be slid anywhere along the wall plate for optimal positioning of your TV. Lock the arm assembly onto the wall plate by sliding the lock lever...
Página 23
3.2 Hang TV onto Arm Assembly HEAVY ! You may need assistance with this step. Position the arm assembly so the elbow is pressed against the wall. Hang the TV onto the arm assembly by first hooking the top support, then pressing the bottom of the TV into the arm assembly until the lock catches.
Página 24
Manage Cables Route your TV cables along the arm assembly and press into the channels in the arm as shown. Cables...
Página 25
Adjustments LEVEL TILT Loosen the two level screws , adjust your TV, Your TV should adjust easily when moved, then stay in place. then tighten the two level screws Adjust the tilt tension knob , by hand, if your TV naturally tilts up or down.
Página 26
TV LATERAL SHIFT HEAVY ! You may need assistance with this step. CAUTION : Avoid potential injuries or property damage! Do NOT adjust the arm position from center for concrete applications. Arm MUST remain centered in wall plate for all concrete applications! For wood stud applications ONLY: Slide the arm assembly along the wall plate...
Página 27
REMOVING THE TV HEAVY ! You may need assistance with this step. Disconnect all cables from the TV. Loosen the lock knob on the vertical TV bracket Pull the release cord on the vertical TV bracket while pulling the bottom of TV from the arm assembly CAUTION: Avoid potential personal injury or property damage! To prevent breaking the locking latch: always pull and hold the release cord...
Página 28
Troubleshooting If you are uncertain about your hardware selection, TV Supplied contact Customer Service at 1-800-359-5520. TV supplied spacers Spacers : Use your TV supplied spacer for flat back TVs : Use your TV supplied spacer and spacer for: (AND you want your TV closer to the wall).
Página 29
Features Adjustments allow fi ngertip control Fully articulating arm extends from of TV or restriction of TV movement 3.62 in. (92 mm) to 25 in. (635.1 mm) Fully articulating arm with three pivot points creates optimal viewing position TV bracket expands to fi...
Página 30
Dimensions in. [mm] TV INTERFACE 23.6 15.7 15.7 11.8 19.7 27.6 WALL PLATE TOP VIEW - EXTENDED SIDE VIEW - EXTENDED 30.9 784 6.5° 24.0 610 16.0 406 25.0 13.0 330 12.1 50.0° 50.0° 22.5 29.2 13.5° FULLY ASSEMBLED MOUNT TOP VIEW - RETRACTED SIDE VIEW - RETRACTED 3.0°...
Página 32
¿Su televisor pesa más de 56,7 kg No — ¡Perfecto! 56,7 kg (125 lb), incluidos Sí — Este soporte NO es compatible. Visite MountFinder.Sanus.com o llame al (125 lb) los accesorios? 1-800-359-5520 (Reino Unido: 0800-056-2853) para encontrar un soporte compatible. ¿Tabiques ¿Hormigón sólido...
Página 33
ESPAÑOL PASO 1 Colocar las placas de sujeción en el televisor Ver página 5 Piezas y elementos de sujeción para el PASO 1 ADVERTENCIA: Este producto contiene piezas pequeñas que, si fuesen tragadas, podrían producir asfixia. NOTA: No todos los accesorios Antes de iniciar el ensamblaje, compruebe que todas las piezas estén incluidas y en buenas condiciones.
Página 34
ESPAÑOL PASO 2 Fijar el módulo del brazo o la placa mural a la pared Ver página 10 Piezas y elementos de sujeción para el PASO 2 ADVERTENCIA: Este producto contiene piezas pequeñas que, si fuesen tragadas, podrían producir asfixia. Antes de iniciar el ensamblaje, compruebe que todas las piezas estén incluidas y en buenas condiciones.
Página 35
NOTA: Si necesita ayuda para determinar la ubicación de la placa mural, utilice la herramienta HeightFinder disponible en sanus.com. IMPORTANTE : Asegúrese de marcar y perforar el centro del montante.
Página 36
Nivele la plantilla de la placa mural y marque la ubicación de los orificios. NOTA: Si necesita ayuda para determinar la ubicación de la placa mural, utilice la herramienta HeightFinder disponible en sanus.com.
Página 37
ESPAÑOL PASO 3 Fijar el televisor a la placa mural Ver página 19 ¡ELEMENTO PESADO ! Es posible que necesite ayuda en este paso. Piezas para el PASO 3 ADVERTENCIA: Antes de iniciar el ensamblaje, compruebe que esta pieza esté en buenas condiciones. Si está dañada, no devuelva el artículo al distribuidor;...
Página 38
ESPAÑOL Organizar los cables Ver página 24 Pase los cables del televisor a lo largo del módulo del brazo y presiónelos sobre los canales del brazo como se muestra. Ajustes Ver página 25 NIVEL Afloje dos tornillos de nivel S , ajuste su televisor, luego ajuste los dos tornillos de nivel S . INCLINACIÓN El televisor debe acomodarse fácilmente al moverlo y luego quedar en su lugar.
Página 39
ESPAÑOL DESPLAZADOR LATERAL DEL TELEVISOR ¡ELEMENTO PESADO ! Es posible que necesite ayuda en este paso. PRECAUCIÓN : Evite el riesgo de lesiones y daños materiales. NO ajuste la posición del brazo desde la posición central para aplicaciones del hormigón. Brazo debe permanecer en la posición central en la placa mural para todas las aplicaciones del hormigón!
Página 40
Verifique el enrosque adecuado del tornillo o del conjunto tornillo/separador. – – Si es demasiado corto, no sostendrá el televisor. Si es demasiado largo, dañará el televisor. . Use los separadores proporcionados con el televisor y los separadores Sanus para: • • televisores con dorso irregular o redondeado dejar un espacio adicional para cables PRECAUCIÓN:...
Página 41
ESPAÑOL Descripción Ver página 29 La placa de sujeción se expande para adecuarse a televisores con patrones de orificios de 200 x 200 mm hasta 700 x 400 mm. El brazo completamente articulado se extiende de 92 mm (3,5") a 381 mm (15"). El brazo completamente articulado crea un movimiento de 3 puntos para alcanzar una posición de visualización óptima.
Página 42
Milestone AV Technologies and its affi liated corporations and subsidiaries (collectively, “Milestone”), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product.
Página 43
Learn ways to get the most out of your space. FACEBOOK.COM/SANUSSYSTEMS Find product updates and more. Learn installation tips, tricks and household know-hows. TWITTER.COM/SANUSSYSTEMS View step-by-step product videos to ease your install experiences. YOUTUBE.COM/SANUSSYSTEMS Find the latest news stories about your favorite SANUS products.
Página 44
If you ever have questions about your SANUS product, give us a call at 1-800-359-5520. We're ready to help! If you ever have questions about your SANUS product, give us a call at 1-800-359-5520. We're ready to help! ‘Monthly prize’...