Loading The Racks - Franke FDW 614 D10P DOS LP C Manual De Usuario

Ocultar thumbs Ver también para FDW 614 D10P DOS LP C:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25

LOADING THE RACKS

CUTLERY RACK
Knives and other utensils with sharp edges must be positioned
with the blades facing downwards.
UPPER RACK
(loading example for the upper rack)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ADJUSTING THE HEIGHT OF THE UPPER RACK
The height of the upper basket can be adjusted: high position to place
bulky crockery in the lower basket and low position to make the most
of the tip-up compartments by creating more space upwards.
The upper rack is equipped with a Upper Rack
height adjuster (see figure), without pressing
the levers, lift it up by simply holding the rack
sides, as soon as the rack is stable in its upper
position. To restore to the lower position, press
the levers (A) at the sides of the rack and move
the basket downwards.
We strongly recommend that you do not
adjust the height of the rack when it is
loaded.
NEVER raise or lower the basket on one side only.
LOWER RACK
(loading example for the lower rack)
8
The third rack was designed
to house the cutlery.
Arrange the cutlery as shown
in the figure.
A separate arrangement
of the cutlery makes collection
easier after washing and improves
washing and drying performance.
Load delicate and light dishes:
glasses, cups, saucers, low salad
bowls.
FOLDABLE FLAPS WITH ADJUSTABLE POSITION
The side foldable flaps can be fold or unfold to optimize
the arrangement of crockery inside the rack.
Wine glasses can be placed safely
in the foldable flaps by inserting
the stem of each glass into
the corresponding slots.
Depending on the model:
– to unfold the flaps there is needed
to slide it up and rotate or release
it from the snaps and pull it down.
– to fold the flaps there is needed
to rotate it and slide flaps down
or pull it up and attach flaps
to the snaps.
For pots, lids, plates, salad bowls, cutlery etc... Large plates and lids
should ideally be placed at the sides to avoid interferences with
the spray arm.
The lower rack has tip-up supports which can be used in a vertical
position when arranging plates or in a horizontal position (lower)
to load pans and salad bowls easily.
The geometry of the rack makes
it possible to place such small
items as coffee cups in the area
in the middle.

Publicidad

Tabla de contenido
loading

Tabla de contenido