Canopy Assembly; Blade Assembly - Craftmade Mobi MOB60 Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If overtightened,
blades may crack and break.
Locate 6 blade screws/lock washers in
hardware pack. Align blade holes with
motor screw holes and attach blade with
screws/lock washers. Repeat this
procedure with remaining blades. Secure
all screws/lock washers with a Phillips
screwdriver.
Note: Tighten blade screws twice a year.
screw
canopy
blade screw/lock washer
page 7
hanging
bracket
screw
motor
housing
blade