Lcd Display; Battery Installation - Makita DMR106 Manual De Instrucciones

18. Battery compartment (covering main battery pack and
back up batteries)
19. Up
20. Left
21. Front
22. Right
23. Back; Battery cover closed
24. Back; Battery cover opened
25. Battery cartridge
26. Button

LCD display:

A. Radio alarm
B. Buzzer alarm
C. Stereo symbol
D. Low battery indicator
E. Clock
F. Frequency
G. RDS (Radio data system)
The following table indicates the operating time on a single charge in Radio mode.
Battery capacity
1.0 Ah
1.1 Ah
1.3 Ah
1.5 Ah
2.0 Ah
3.0 Ah
4.0 Ah
5.0 Ah
: Cluster Battery
: Slide Battery
Note:
Table regarding to the battery operating time above is for reference. The actual operating time may differ with the type of
the battery, charging condition, or usage environment.
Installing or removing Slide battery
cartridge (Fig. 4 & 5)
• To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
6
Battery Cartridge Voltage
7.2 V 10.8 V
BL7010
BL1014
H. Sleep status
I. AM/PM for clock

Battery Installation

Note:
Keeping back up batteries inside the compartment
prevent stored data in preset memories from being lost.
1. Pull out the battery compartment locker to release
battery compartment. There are main battery pack
compartment and back up battery compartment.
(Fig. 2)
2. Remove back up battery compartment cover and
insert 2 fresh UM-3 (AA sizes). Make sure the
batteries are with correct polarity as shown inside the
compartment. Replace the battery cover. (Fig. 3)
3. After back up batteries are inserted, insert the main
battery pack to power radio. The suitable battery
packs for this radio listed as the following table.
14.4 V 18 V
BL1411G,
L1451
BL1811G,
L1851
BL1415,
BL1413G,
L1453
BL1815,
BL1813G,
L1853
BL1415N
BL1815N
BL1820
BL1430
BL1830
BL1440
BL1840
BL1450
BL1850
it into place. Always insert it all the way until it locks in
place with a little click.
• If you can see the red indicator on the upper side of the
button, it is not locked completely. Install it fully until the
AT SPEAKER OUTPUT =
50 mW + 50 mW (unit: Hour)
(Approximately)
In Bluetooth
In radio or AUX with USB
charging
5.5 0.8
1.5
5.5
1.8
1.5
1.8
7.5
2.0
2.0
8.5
2.5
11 3.2
4.0
16.5
5.0
5.5
22
6.5
6.5
27.5
®
8