Light Kit Assembly - Craftmade Illusion ILU56 Guia De Instalacion

8. Light Kit Assembly.

Remove 1 screw from motor plate on
underside of motor assembly and
partially loosen the other 2 screws.
Align slotted holes in center of fitter
plate with loosened screws in motor
plate, allowing molex connections
from motor housing to come through
hole in middle of fitter plate. Twist
fitter plate to lock. Re-insert screw that
was just removed and securely tighten
all 3 screws with a Phillips screwdriver.
[Refer to diagram 1.]
Remove 1 screw from underside of
fitter plate and partially loosen the
other 2 screws. [Refer to diagram 1.]
Connect WHITE wire from motor
housing to WHITE wire from LED light
kit. Connect BLACK (or BLUE) wire
from motor housing to BLACK wire
from LED light kit. Be sure molex
connections snap together securely.
[Refer to diagram 2.]
Carefully arrange wiring within fitter
plate. Align slotted holes in LED light
kit with loosened screws in fitter plate.
Twist LED light kit to lock. Re-insert
screw that was previously removed
and tighten all 3 screws securely. [Refer
to diagram 3.]
To attach glass shade, align grooves on
glass shade with nodules on inside of
LED light kit. Push up gently on glass
shade and then turn glass shade to the
RIGHT (clockwise) until it no longer
turns. [Refer to diagram 4.]
NOTE: Pull down VERY GENTLY on glass
shade to make sure that glass shade is
secure.
motor plate
diagram 1
molex
connections
diagram 2
diagram 3
LED light kit
diagram 4
page 7
motor assembly
fitter plate
molex connections
motor assembly
fitter plate
LED light kit
motor assembly
fitter plate
LED light kit
nodule
groove
glass shade