Automated Learning Process./Activating Code - Craftmade Illusion ILU56 Guia De Instalacion

10. Automated Learning Process./Activating Code.

CAUTION: The wall and/or handheld remote
control can be programmed to multiple
receivers or fans. If this is not desired, turn wall
switch off to any other programmable receiver
or fan.
Restore electrical power and then, if using
wall control, set slider switch on wall control
to the ON position. Within 60 seconds of
turning on the wall control, press and hold
the fan SET button on the wall control for 5
seconds or until light blinks twice. [Refer to
diagram 1.]
Turn power off again for at least 5 seconds
and then turn power back on. Within
60 seconds of restoring the power, press and
hold the fan SET button on the handheld
remote control for 5 seconds or until light
blinks twice. [Refer to diagram 2.]
Test the light and fan functions to confirm the
learning process is complete--see Section 12
on the following page.
Select a faceplate (almond or white) and
press firmly onto front of wall control that was
previously installed to the outlet box on the
wall. [Refer to diagram 1.]
Attach black faceplate to front of handheld
remote control; press down firmly. [Refer to
diagram 2.]
NOTE: When attaching the faceplate(s), make
sure to press each of the 4 little posts on the
backside of the faceplate(s) completely into
the corresponding holes on the front of the
wall control(s).
slider
switch
diagram 1
diagram 2
page 9
wall control
III IV
II V
VI
I
OFF ON
SET button
handheld
remote control
III IV
II V
VI
I
SET button
faceplate
(almond
or white)
faceplate
(black)
OFF ON