Getting To Know Your Unit; Set Up Instructions - Campbell Hausfeld XT251000 Manual De Instrucciones

GETTING TO KNOW YOUR UNIT

Flush-type Grease Fitting
Spindle

SET UP INSTRUCTIONS

* Items shown in Set Up Instructions are not included with this tool.
u The air compressor used with your angled die grinder must be able to maintain
a minimum of 90 PSI when the tool is being used. An inadequate air supply can
cause a loss of power and inconsistent tool output/performance.
u A pressure regulator—used at the tool--is helpful to control the operating pressure
of the tool and maintain 90 PSI.
u Use an oiler to provide oil circulation through the tool and a filter to remove liquid
and solid impurities which can rust or "gum up" internal parts of the tool.
u To disconnect a coupler/plug from a system set-up: push the coupler and plug
together before pulling the coupler sleeve back and separating the coupler and
plug.
Air Regulator Adjustment Screw
1/4 inch
Collet Nut
Collet Opening
Air Hose
BEST PRACTICES
Trigger
17 mm (Collet Nut) Wrench
12 mm (Spindle) Wrench
Plug
Quick
Coupler
3
Air Inlet
Exhaust Port