Getting To Know Your Unit; Set Up Instructions - Campbell Hausfeld XT250000 Instrucciones De Operación

GETTING TO KNOW YOUR UNIT

Collet
Opening
1/4 inch Collet Nut

SET UP INSTRUCTIONS

* Items shown in Set Up Instructions are not included with this tool.
u The air compressor used with your straight die grinder must be able to maintain
a minimum of 90 PSI when the tool is being used. An inadequate air supply can
cause a loss of power and inconsistent tool output/performance.
u A pressure regulator—used at the tool--is helpful to control the operating pressure
of the tool and maintain 90 PSI.
u Use an oiler to provide oil circulation through the tool and a filter to remove liquid
and solid impurities which can rust or "gum up" internal parts of the tool.
u To disconnect a coupler/plug from a system set-up: push the coupler and plug
together before pulling the coupler sleeve back and separating the coupler and
plug.
Spindle
17 mm (Collet Nut) Wrench
12 mm (Spindle) Wrench
Air Hose
BEST PRACTICES
Air Regulator Adjustment Screw
Trigger
Quick
Coupler
3
Air Inlet
Exhaust Port
Plug