Replacing Of The Illuminant; Trouble Shooting - Nevir NVR-4497 CTNFD Manual De Instrucciones

15. Afterwards remove the small pieces of ice.
16. Wipe and dry the appliance and door seals with dry and soft cloths.
17. After cleaning leave the door open for some time to ventilate the
appliance.

5.2 Replacing of the illuminant

The appliance is equipped with an LED-illuminant. To replace the illuminant,
please contact the aftersales service or a qualified professional. Illuminants
and the replacing of illuminants are not included in guarantee.

6. Trouble shooting

WARNING! Before you start troubleshooting, disconnect the
appliance from the mains. Any work not described in this instruction
manual must be carried out by a qualified professional only.
POSSIBLE CAUSE
The appliance does not work at all.
 The plug of the appliance is not
connected to the socket.
 The plug has become loose.
 The socket is not supplied with
energy.
 The fuse is switched off.
 The voltage is too low.
The compressor does not work at all.
 Incorrect energy supply.
The compressor operates for too long.
 The appliance has been switched
off for a while.
 Doors opened too often or too
long.
MALFUNCTION
 Check the corresponding socket
 Check the fuse box.
 Compare the data on the model
 Check the energy supply.
 The appliance needs some time to
 Do not open the door too
Unsatisfactory cooling capacity.
MEASURE
by connecting it with another
appliance.
plate with the data of your energy
supplier.
reach the preset temperature.
often/too long.