Toyota Bluetooth SWC Manual Del Propietário página 16

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 36
Adding contact list entries
You can store a list of names and phone numbers in the hands-free system's contact list.
The contact list can support up to 50 entries. The contact list is only available when a handset
device is connected to the hands-free system.
You can enter up to 50 digits for each contact list entry. You can also use +, *, or # characters when
dialling a number. "WAIT" and "PAUSE" commands are also accepted.
Note: For safety reasons, it is recommended that contact list entries be added while the
vehicle is stationary.
Adding a contact list entry
1
Press and hold the MODE button.
The hands-free system responds: Phone menu. {Say a command}.
2
When prompted, say "CONTACT LIST".

If the hands-free system responds: Contact list is empty. Do you wish to add a contact? Say
"YES".
or
If the hands-free system responds: Contact list. {Say a command}. Say "ADD CONTACT".
4
When the hands-free system responds: Say the name. Recite the name of the contact to be
stored.
If an error is detected, the hands-free system asks you to try again.
If it accepts the name, the hands-free system responds: Say the number for <name>.
5
Dictate the number as an entire number (without pauses between digits).
or
Dictate the number as a series of segments (for example, say the 1st  digits, then the next 
etc.), until you have dictated the entire number.
The hands-free system repeats the number it heard.
6
When you have correctly entered the entire phone number, say "STORE" (or "YES") to store
the contact.
The hands-free system responds: Contact added. Would you like to add another contact?
7
Say "NO" to exit contact list.
or
Say "YES" to add another entry.
Note: Speak numbers as continuous digits. For example, dictate 555-2211 as "5-5-5-2-2-1-1",
not "5-5-5-twenty-two-eleven."
Note: To delete a phone number segment, say "CLEAR" when prompted for the next
segment. The hands-free system responds Last String Cleared, and echoes any remaining
segments, and waits for you to dictate a new segment.
Note: To delete all phone number segments dictated so far, say "CLEAR ALL" when prompted
for the next segment. The hands-free system clears all segments and returns to the Number
Please? prompt.
Bluetooth
SWC
15
®

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido