Husqvarna M-ZT 52 Manual Del Operador página 17

MANTENIMIENTO
NOTA: Para garantizar la precisión del
transmisión del equipo de corte debe instalarse
antes de nivelar el equipo.
1. Use guantes resistentes. Gire cada punta
2.
parte inferior de la punta de la cuchilla en
hacia arriba o hacia abajo en la ranura hasta
iguales. Conserve la medida.
3.
delantera a la trasera. Cambie de posición los
pernos de montaje hacia arriba o hacia abajo
de la cuchilla estén de 3.175 mm a 9.525 mm
la cuchilla delanteras.
68
4.
de las cuchillas deben estar niveladas de lado
puntas de las cuchillas deben estar en un
nivel lado a lado.
NOTA: Esto colocará el equipo de corte en una
posición de medida estándar. En función del tipo
de pasto que éste cortando o las condiciones
adicionales para lograr el corte deseado.
Ruedas de apoyo
INFORMACIÓN IMPORTANTE Ajuste las
posiciones:
• Posición superior para hierba de 38 a 64 mm
• Posición intermedia para hierba de
38 a 102 mm
• Posición inferior para hierba de 38 a 102 mm
mm del suelo. No ajuste las ruedas para soportar
OPERATION
Read the Safety section and following pages, if
Training
riding mowers.
prior to attempting to move the mower under its
until becoming comfortable with controls, use
a reduced throttle speed and reduced ground
furthest forward or reverse positions during initial
operation.
First time users must become familiar with the
mower's movement on a hard surface, such
to operate on turf. Until the operator becomes
comfortable with the mower controls and zero
Steering
To move forward and backward
control lever controls the right wheel.
Moving
Machine By Hand in the Operation section) to
its own power, the operator must sit in the seat
and start the engine (see Before Starting in the
Operation section). Adjust the engine speed to
the blades at this time. Rotate control levers
inward. As long as the control levers have not
will not move.
neutral position and the mower will stop moving.
levers forward to the neutral position and mower
will stop moving.
To turn to the right
While moving in a forward direction, pull the right
maintaining the position of the left lever, this will
slow the rotation of the right wheel and cause the
machine to turn in that direction.
To turn to the left
While moving in a forward direction pull the left
maintaining the position of the right lever, this will
slow the rotation of the left wheel and cause the
machine to turn in that direction.
To zero turn
forward position and the other in the reverse
position, complete the turn.
Roll Bar and Safety Belt
Operate the unit with the roll bar in the raised and
no rollover protection when the roll bar is down.
seat belt. Raise the roll bar as soon as clearance
permits.
WARNING!
when the roll bar is in upright position.
17