Extension Cables; Assembling The Accessories; Glass Turntable - CASO DESIGN SMG20 Manual Del Usuario

Horno microondas y grill
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 126
The electrical outlet must be protected by a 16A safety cut-out switch, separately from other
electricity consumers.
The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or gangs is
prohibited because of the danger of fire that is involved with this.
Make sure that the power cable is undamaged and has not been installed under the oven or
over hot or sharp surfaces.
This appliance must be electrically grounded. In case of a short circuit grounding will protect
against electric shocks because the electrical current is diverted through the grounding lead.
The appliance is fitted with an appropriate cable with a ground lead and a grounded safety
plug. The plug must be inserted into a properly installed and grounded outlet.
The electrical safety of the device is only guaranteed if the device is connected to a properly
installed protective conductor system. Operations using an electrical outlet without a protective
conductor are prohibited. If in doubt, have the house installation checked over by a qualified
electrician.
The manufacturer cannot be made responsible for damages that are caused by a missing or
damaged protective conductor.
11.6.1
The power cable is kept intentionally short to reduce the risk of tangling or presenting a
tripping hazard.
If a longer cable or an extension cable is required:
1) The power rating of the cable or extension cable must be no less than the rating of the
appliance.
2) The extension cable must a three-lead (grounded) cable.
3) Arrange the long cable so that it does not hang down from table or counter tops where it
can be pulled by children and that it does not present a tripping hazard.

11.7 Assembling the accessories

1 Hub (underside)

2 Glass turntable

3 Turntable drive
4 Rolling ring
Assemble the glass turntable as follows:
 Insert the rolling ring
 Place the glass turntable inside the appliance so that the grooves on the underside of
the glass dish lock into the turntable drive.
caso SMG20

Extension cables

11.7.1 Glass turntable
52

Publicidad

Tabla de contenido
loading

Tabla de contenido