Maintenance Table - EMAK KTK 102H Serie Manual De Instrucciones

13. MAINTENANCE TABLE

Operation
MACHINE
Safety checks/check controls
Tyre pressure check
Check the rear/lateral discharge guards. Check the
grass catcher bag and lateral discharge chute.
General cleaning and inspection
Checking for any damage to the machine. If
necessary, contact the Authorised Service Centre.
Charging the battery
Complete bolt and screw check
Cutting device positioning and sharpening check
Transmission belt check
Cutting device control belt check
Brake regulation and check
Drive regulation and check
Cutting device gear and brake check
General lubrication
Replacing cutting device
Replacing the transmission belt
Replacing the cutting device control belt
ENGINE *
Checking/topping up fuel level
Check/top-up engine oil
Replacement of the engine oil
Air filter cleaning and check
Air filter replacement
Fuel filter check
Fuel filter replacement
Spark plug points cleaning and check
Replace the spark plug
* Consult the manual supplied with the engine for a complete list of
maintenance operations and the corresponding intervals
** At the first signs of any malfunction, contact your Dealer immediately
*** The operation must be carried out by your Dealer or a Authorised Service Centre
*** General lubrication of all joints should also be carried out whenever
the machine is to be left unused for a long period
Interval (hours)
First time Subsequently every
Before each use
Before each use
Before each use
Before each use
Before each use
EN - 27
After each use
After each use
Before storage
25
25
25
25
25
25
25
25
100
-
-
*
*
*
*
*
*
*
Paragraph
/ Notes
par. 6.2
par. 6.1.3
par. 6.1.4
par. 7.6
-
par. 7.5
***
***
***
***
***
***
****
***
** / ***
** / ***
par 7.2
par 7.3
*
*
*
*
*
*
*