The Handle Installing; Shelves; Electrical Connection - CASO DESIGN WineChef Pro 40 Manual Del Usuario

12.5.3

The handle installing

The wine cooler comes with one metal stainless steel handle. To install simply screw them to
the door with the supplied screws.
To do this, slide the rubber seal on the back of the door to the side to lay open the predrilled
holes. Use the included screws to install the
handle on the door.
Then reinsert the rubber seal in the correct
position.
12.5.4

Shelves

Storrage depending on kind of bottle and size.
You can store 8 bottles on each shelf.
You can remove each shelf to store larger bottles.
To remove a shelf: Remove all bottles from the shelves. Lift the shelf upwards and the gently
pull it out, (eventually untighten the screws).
Please note
► Ensure that the shelves are firmly engaged in place before storing any bottles.
► Spread your bottles out as evenly as possible over the shelves, so weight is not
concentrated in one point; and make sure your bottles will not touch the back of the
cabinet.

12.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
32