Astralpool POOLWATCH TOP ECO 29485 Manual De Instrucciones página 26

4. POOLWATCH TOP ECO INORGANIC CHLORINE INSTALMENT
PoolWatch Top Eco Inorganic Chlorine is presented in a PVC panel (60 cm x 60 cm)
1.- Fix the panel to the wall with the separators provided.
2.- Connect the set to a 230 V ac. with a direct earth connection (they do not have to depend on a filter working).
3.- Put the pH probe (10) and the probe ORP (11) in the analysis chamber of probes (12). One of the lids of access to the location area
must be unscrewed. Take the pH and the ORP probes and remove the plastic protections in both extremes, then screw it in the
location zone.
4.- Connection of pH probe. Take the cable connection (7) and connect it to the pH electrode through the extreme ended in a thread.
The 7 cable is the one on the left. Its connections correspond to the positions 31 and 32 in the grid.
5.- Connection of ORP probe. Take the cable connection (8) and connect it to the pH probe through the extreme ended in a thread. The
8 cable is the one on the righ of the cable set pH probe. Its connections correspond to the positions 35 and 36 in the grid.
6.- Put the cell of Inorganic Chlorine (17) in the zone (B) of the analysis chamber (A). Unscrew the lid of access to zone (B). This lid has
two parts: a fixing thread and a lid. We take the fixing thread, we put it though the wire extreme (18) of the Inorganic Chlorine cell
and we proceed to wind the cell in its location (B). The connections of the Inorganic Chlorine cell to the grid are the following;
Heald (Blue) 33 (negative), Active (translucent) 34 (positive)
7.- It is advisable to keep all the protections and lids for a possible future usage (for instance, during a long stop, due to repairs, etc.)
8.- The water connection that feeds the water inlet to the PoolWatch Top Eco Inorganic Chlorine must be as similar as possible to the
water in the pool. This is why we recommend to make the instalment according to what is shown in the paragraph enclosed and to
filter part of the water through the bottom of the pool.
NOTE: If the swimming pool has not been yet built, ask the Department of Customer Assistance in AstralPool.
ATTENTION: It is important that the feeding in PoolWatch Top Eco Inorganic Chlorine has a good earth connection, as a security and
also to guarantee its proper functioning. Otherwise, it could provoke instability in the parameters reading. Taking this problem into
account, we advise to give the PoolWatch Top Eco Inorganic Chlorine a proper earth connection..
5. INSTALMENT DIAGRAM POOLWATCH TOP ECO DESINFECTION WITH LIQUID CHLORINE (SODIUM HYPOCHLORITE)
Net water
Pump recirculation
Compensation tank
NOT TO PLACE THE TANKS OF CHEMICAL PRODUCT UNDER THE DOSING PUMPS.
THE CHEMICAL PRODUCTS MUST BE FAR FROM THE DOSING PUMPS AND OF THE EQUIPMENT POOLWATCH TOP ECO INO
SWIMMINGPOOL
Non stop flocculation unit
Filter
Exchange temperature
6
RGANIC CHLORINE.
Ref:PoolWatch Top-Eco-29485-gb-W01