Turning Power On/Off - Sharp PN-L803CA Manual De Instalación

Caution
• Turn on the monitor first before turning on the computer or
playback device.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.
Turning on the main power
Main power switch
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• For a complete electrical disconnection, pull out the main
plug.
Turning power on
Press the POWER button to turn the power ON.
Power LED
Status
Green lit Power on
Orange lit Power off (Standby mode)
Green flashing Input signal waiting mode

Turning Power On/Off

nDate/time setting
• If the time has yet to be set when the monitor is first turned
• Be sure to set the date and time.
• The date/time setting screen will close automatically if
•
•
•
•
•
•
Turning power off
Turning power off with monitor buttons
POWER button
1. Touch the POWER button.
Status of the monitor
2. Touch [OK].
• If about 15 seconds elapses while the recognition screen
Turning power off with remote control unit
1. Press the POWER button.
on, the date/time setting screen appears. Set the date and
time.
DATE/TIME SETTING
/ /
01 / 01 / 20 15
OK···[ENTER] CANCEL···[RETURN]
1. Press or to select the date and time, and
press or to change the numerical values.
ENTER
2. Press .
no operation is performed for about 15 seconds. The
date and time can be set using DATE/TIME SETTING
from the SETUP menu when the date/time setting screen
disappears.
TIPS
Set the date in "Month/Day/Year" order.
Set the time on a 12-hour basis.
The clock is maintained by the internal battery.
If you already set the time but the date/time setting
screen appears when the power is turned on, the
internal battery may be exhausted. Please contact
your local SHARP servicing dealer or service center for
assistance with battery replacement.
Estimated service life of the internal battery: About 5
years (depending on monitor operation)
The initial battery was inserted at the factory when the
monitor was shipped, so it may run out of power before
its expected operation life.
The recognition screen appears.
The power is turned off. (Standby mode)
TIPS
appears, the power will automatically turn off.
The power is turned off. (Standby mode)
: :
12 : 00 AM
7
E