Operation - Klarstein STUDIO LIGHT & FIRE Serie Manual De Instrucciones

OPERATION

Manual operation
The On/Off switch is must be switched to 'I' to begin operating the fire.Operation is via
by the buttons located on the left hand side of the fire under the canopy. The fire will
beep to indicate that it is powered up.
• Turn on the appliance by pressing the power switch on the main unit.
• To activate the flame effect, press the Flame button. The indicator light will
illuminate, this can be activated without the heater operating.
1 press: low brightness
2 or 3 presses: increase brightness
4 presses: switch the flame effect off
• The fan heater has two separate settings that are selected by pressing each function
button:
Button 1: 1000 W:
Button 2: 2000 W
To turn the heater off press the function button again and set the power switch to 0.
Remote control and button functions
Power Button
Flame Button
Arrow Buttons
Heating Level
Downlight
Timer Button
Press this button to turn the appliance on and off.
Press this button to cycle between the three flame effect
settings.
Use the buttons to change the desired room
temperature. The temperature currently selected will be
displayed on the diplay.
Press this button to change between the available
heating levels.
Press this button to turn the downlights on and off.
Press to this button to turn the timer settings on and off.
EN
21