Klarstein STUDIO LIGHT & FIRE Serie Manual De Instrucciones página 22

EN
22
Before using the weekly timer, the clock must be set.
Clock
To do this:
• Press the Clock button, then use the arrow buttons
to select the day.
• Press the Clock button again, then use the arrow
buttons to select the hour value (24 hour format).
• Press the Clock button again, then use the arrow
buttons to select the minute value.
Your fire includes a 7 day timer, which allows you to
Week Timer
set two periods of operation per day. The fireplace will
operate with the previously used settings for the heating
level, desired temperature and flame colour.
To set the timer press the TIMER button. The unit will
display the day, period, and the ON or OFF time when
you set it. For each period both the ON and OFF times
must be set.
For each period:
1. Set the ON hour value using the arrow buttons,
press the TIMER button to confirm.
2. Set the ON minute value using the arrow buttons,
press the TIMER button to confirm.
3. Set the OFF hour value using the arrow buttons,
press the TIMER button to confirm.
4. Set the OFF minute value using the arrow buttons,
press the TIMER button to confirm.
The fire will then move onto the next period/first period
of the following day, allowing this to be programmed
in the same way. The days and periods can be scrolled
through by repeatedly pressing the TIMER button.
To clear an operational period set the ON and OFF
times to the same value.
Your fire includes "Open Window Detection" which
Open Window
will stop the heating function after a period of time if lhe
Detection
room temperature is not increasing, on the assumption
that there is an open door or window. This is designed
to save energy and be turned on and off using the
AUTO button. When the function has been activated
"AUTO" will flash on the screen.