Safety Cut-Out; Cleaning And Care - Klarstein STUDIO LIGHT & FIRE Serie Manual De Instrucciones

SAFETY CUT-OUT

This appliance is fi tted with a safety cut-off which will operate if the fi re overheats (e.g.
due to blocked air vents). For safety reasons, the fi re will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15
minutes. Reconnect to the mains supply and switch on the appliance.
Do not open this product. There are no userserviceable parts inside.

CLEANING AND CARE

Warning: Danger of electric shock
Always disconnect from the mains supply before cleaning the wall fi re.
Do not allow water or other liquids to run into the interior of the
product.
Caution: Danger of burns
Allow the product to completely cool before handling or cleaning it.
Cleaning the electric electric fi replace
• Clean this appliance periodically by lightly running a vacuum cleaner nozzle over
the guards to remove any dust or dirt that may have accumulated inside or on the
unit.
• Do not use harsh detergents, chemical cleaners or solvents as they may damage the
surface fi nish of the plastic components.
EN
23