Bluetooth Connection - Lenco PA-30 Manual Del Usuario

BLUETOOTH CONNECTION

- Once the power switch is turned to "On",
Bluetooth "BT" mode is set as default.
- Blue LED indicator will be flash in pairing
mode. The red LED display will show "bt"
- Turn on the Bluetooth function on your
device and search for "Lenco PA-30" then
press to connect.
- Connected sound signal will be heard and
the blue led connection indicator will stop
blinking and stay steady.
- Bluetooth connection is completed.
- Select the music from your Bluetooth device and start playing.
- Holding the BT OFF key to disconnect paired device and enter pairing mode.
FM RADIO
- Press the "Source" button and select Radio, the FM Radio Frequency will show on
the red LED display.
- Press play/pause key to auto search and store.
- Press and hold the TU
station. Short press them to fine tune.
USB PORT
- Press the "Source" button and select
USB. USB will show on the red LED
display.
- Insert the USB stick.
- Select your favorable music by
pressing TU
- Press "REPEAT" once to repeat the
current selected song.
- Press "REPEAT" the 2
all songs.
- Press "REPEAT" the 3
- Press "REPEAT" again to turn repeat off.
It will automatically switch to USB mode once insert the USB stick.
Important: The USB port is intended for data transfer only. Other devices cannot be
used with this USB connection. The use of USB extension cords is not recommended.
LINE IN
or TU
or TU .
nd
time to repeat
rd
times to random
Bluetooth function
buttons to choose the next stored available
1
SOURCE
7
2
TU+/
TU-/
3
REP