Truper CANT-6X-2 Manual Del Usuario página 28

Operation
• Before working the final piece, use scrap material to get familiar in the use of the jointer.
• Remember keeping your hands away from the cutter head. Use the cutter head guard and using push
CAUTION
blocks or poles to push the material towards the cutter head.
• Once all the adjustments are performed in the jointer start the edging or planing job.
• Start the jointer (see page 11) and wait until it reaches its full speed to start working.
• Set the work piece onto the in feed table and rip fence. Push the work piece towards the cutter head. The piece will make
contact with the guard and will push it aside to make contact with the blade. Continue pushing the piece while applying
pressure down on the side of the piece resting onto the out feed table. Keep pushing until the work piece is completely set
onto the out feed table and the guard returns to its place.
Out feed
table
Edging
12
ENGLISH
In feed
Planing
table
Start Up