Maintenance - Truper CANT-6X-2 Manual Del Usuario

Maintenance

Cleansing
• Keep the interior of the cabinet free of sawdust and
wood dust. Disconnect the edge planner. Vacuum the
inside of the cabinet or blow with an air hose.
Double-check not to use air pressure not higher than 50
PSI since the air pressure may damage insulating.
• The jointer mechanisms can be cleaned with a strong
brush.
• Tar or resin accumulation shall be cleaned with a solvent
like turpentine or mineral alcohol, a strong wire brush and
steel fiber.
Lubrication
• The jointer is built with sealed bearings into the motor
housing and also into the assembly on the disc center
therefore it needs no additional lubrication.
Blade replacement
• Move the rip fence back until it stops and remove the
guard to uncover the cutter head.
• Loosen the screws (A) to remove the blade and the
counter-blade.
• Turn the lifting screws (C) counterclockwise until they
stop.
• Follow the same mechanism to remove the remaining
two sets of blades and counter-blades.
• Before replacing blades double-check the counter-blades
are completely clean and free of gum or resin.
• Set the counter-blades and blades inside the cutter head
slots.
• Push the blades down as much as possible using a piece
of wood and tighten the screws (A).
• Set the gauge (D) onto the cutter head. The blade shall
make contact with the inner side of the gauge, sticking out
0,060" from the cutter head diameter.
• If the blade is not well calibrated slightly loosen the
screws (A) clockwise using the key included.
• Adjust the blade height turning the lifting screws (C)
cusing one of the Allen keys included. Turning clockwise
will raise the blade and counterclockwise will lower it.
Honing the blades
• After a long period of use the blades can get dull.
• Hone the worn blades assembled in the cutter head to
prevent the blades loose alignment.
• Cover the in feed table with paper to prevent damages.
Lower it.
• Move the cutter head until the bevel in the blade is aligned
with the table surface.
• With silica carbide stone hone the blade manually. Use the
previously protected with paper in feed table as a guide.
Tables surface
• The table surface is made of unfinished metal. With
the passing of time it accumulates oxide when not
serviced. When using a brush apply a thin layer of
WD-40 to prevent oxidation.
• If oxide has accumulated already on the table surface,
use WD-40 and a fine wire flannel to remove it.
• A good preventive measure to prevent the setting of
oxide is using quality wax paste onto the table surface.
Electric connection diagram
WARNING
BEFORE GAINING ACCESS TO TERMINALS ALL
INPUT SYSTEMS NEED TO BE DISCONNECTED
U1 Z1 V1
110 V
Clockwise.
U1 Z1 V1
220 V
Clockwise.
D
C
A
Cutter
head
U2 Z2 V2
U2 Z2 V2
Counter-blade
Blade
ENGLISH
13