Technical Data; Power Requirements - Truper CANT-6X-2 Manual Del Usuario

Technical data

Code
Description
Voltage
Frequency
Current
Motor speed
Weight
Cutter head speed
Table measurements
Duty cycle
Conductors
Insulating
WARNING
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
WARNING

Power requirements

WARNING
The tool shall be grounded while being used to prevent electric shock.
The Jointer shall be set as close as possible to the main power source. Double-check the source has the same voltage as the
one indicated in the motor nameplate.
WARNING
This tool shall be grounded.
Power cables are coded with the following colors:
CAUTION
WARNING
When using an extension cable, verify the gauge is enough for the power that your product needs. A
lower gauge cable will cause voltage drop in the line, resulting in power loss and overheating. The following table shows
the right size to use depending on cable's length and the ampere capability shown in the tool's nameplate. When in
doubt use the next higher gauge.
Ampere
Capacity
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
120 minutes work and 30 minutes idle. Maximum 6 hours per day.
16 AWG x 3C with insulating temperature of 221 °F
Class I
Power cord grips used in this product: Type "Y".
Thermal insulation on motor winding: Class B.
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
Before gaining access to the terminals all power sources should be disconnected.
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE-2006
CANT-6X-2
16917
6" Jointer
/
110 V 220 V
60 Hz
12 A / 6,2 A
3 450 RPM
251.3 LB
5 205 RPM
length: 48 1/2" | width: 7 1/4"
height: 32 1/2"
IP Grade
Build quality: Basic Insulation.
Authorized Service Center.
GREEN
WHITE
BLACK
Extension gauge
from 6 ft to 49 ft
18 AWG( * )
16 AWG
14 AWG
8 AWG
IP44
GROUND
NEUTRAL
CURRENT
| higher than 49 ft
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
3