BRS-LC
6.6.1 Securing the clamping prism
1
1
Clamping device
Fig. 9
Securing the clamping prism
1 Insert the clamping prism (2) into the clamping device (1) from above.
2 Attach with cylinder head screw (3).
6.6.2 Mounting the reamer
NOTICE
• When changing the reamer, only use tools with a suitable width across flats.
Reamer holder AF 27 mm, reamer AF 17 mm.
1
1
Reamer holder
Fig. 10
Mounting the reamer
1 Mount the reamer (2) into the reamer holder (1).
2 Tighten the reamer (2) (min. 20 Nm).
BAL.0123 • 2020-12-15
2
3
2
Prism
2
3
2
Reamer
6 Commissioning
3
Cylinder head screw
3
Tool
EN - 17