Preparations At The Workplace; Charging The Battery; Inserting The Battery; Removing The Battery - Hilti SFD 2-A12 Manual De Instrucciones

5

Preparations at the workplace

CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or
before changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.

5.1 Charging the battery

1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.

5.2 Inserting the battery

CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible
click.
3. Check that the battery is seated securely.

5.3 Removing the battery

1. Press the battery release buttons.
2. Remove the battery from the tool.
5.4 Fitting the belt hook (optional)
CAUTION
Risk of injury by falling power tools!
▶ Check that the belt hook is fitted securely before beginning work.
The belt hook enables you to attach suitable power tools to your belt, where
they are close to your body. It can be fitted to allow attachment on the left
or right side of the body.
1. Remove the battery from the power tool.
2. Secure the belt hook with 2 screws to the base of the power tool.
*2235440*
Printed: 19.08.2019 | Doc-Nr: PUB / 5509398 / 000 / 00
2
2235440 English 9