Product Safety Information; Product Specifications - Ingersoll Rand 115 Serie Especificaciones Del Producto

Product Safety Information

Intended Use:
These Air Percussive Hammers are designed for hammering, punching, cutting, chipping and
scraping material through repetitive application of linear impacts of a tool steel that is retained
and driven by the Hammer.
For additional information refer to Product Safety Information Manual Form 04581450.
Manuals can be downloaded from ingersollrandproducts.com.
Prior to Use
●
Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel or jet
fuel. Use only recommended lubricants.
● Use only proper cleaning solvents to clean parts. Use only cleaning solvents which meet
current safety and health standards. Use cleaning solvents in a well ventilated area.
Tools are coated inside and out with rust-resisting oil before leaving the factory. Before using the
tool, remove this oil by dipping the tool in a suitable cleaning solution to wash the oil from the
exterior. Pour about 6 cm
tool for about 15 seconds. Dry the tool immediately after cleaning, pour 3 cm
No. 10 Oil into the air inlet and again operate the tool for 5 seconds to lubricate all working parts.

Product Specifications

Type of
Models
Handle
115, 115-EU Pistol Grip 5000
116, 116-EU Pistol Grip 3500
117, 117-EU Pistol Grip 2000
116H, 116H-EU Pistol Grip 3500
117H, 117H-EU Pistol Grip 2000
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
* K = Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
47135447_ed3
WARNING
of a clean, suitable, cleaning solution into the air inlet and operate the
3
Stroke
Blows
Length
per
Minute
Inch (mm) † Pressure (L
1-5/8 (41)
2-5/8 (67)
3-1/2 (89)
2-5/8 (67)
3-1/2 (89)
WARNING
Sound Level dB (A)
(ISO15744)
) ‡ Power (L
p
101.4 112.4
101.4 112.4
100.5 111.5
101.4 112.4
100.5 111.5
EN
of Ingersoll Rand
3
Vibration (m/s )
2
(ISO28927)
) Level *K
w
14.8 2.2
14.8 2.2
9.2 3.0
14.8 2.2
9.2 3.0
EN-1