Kenwood KDC-X700 Manual De Instrucciones página 22

BLUETOOTH®
Make a call
You can make a call from the call history, phonebook, or dialing the number. Call by
voice is also possible if your mobile phone has the feature.
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the following table), then press the
knob.
3 2
Repeat step until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press and hold to exit.
To return to the previous setting item, press
CALL HISTORY (Applicable only if the phone supports PBAP)
1 Press the volume knob to select a name or a phone number.
• "INCOMING", "OUTGOING", or "MISSED" is shown on the lower part of the display
to indicate the previous call status.
• Press DISP to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history.
2 Press the volume knob to call.
PHONE BOOK (Applicable only if the phone supports PBAP)
1 Turn the volume knob quickly to enter alphabet search mode (if the phonebook
contains many contacts).
The first menu (ABCDEFGHIJK) appears.
• To go to the other menu (LMNOPQRSTUV or WXYZ1
• To select the desired first letter, turn the volume knob or press S / T, then
press the knob.
Select "1" to search with numbers and select "
2 Turn the volume knob to select a name, then press the knob.
3 Turn the volume knob to select a phone number, then press the knob to call.
• The phonebook of the connected phone is automatically transferred to the unit when
pairing.
• Contacts are categorized as: HOME, OFFICE, MOBILE, OTHER, GENERAL
• This unit can display only non-accent letters. (Accent letters such as "Ú" is showns as
"U".)
18
.
), press J / K.
*
* " to search with symbols.
NUMBER DIAL 1 Turn the volume knob to select a number (0 to 9) or
character ( , #, +).
2 Press S / T to move the entry position.
1
Repeat steps
phone number.
3 Press the volume knob to call.
(or using RC-406)
1 Press the number buttons (0 to 9) to enter the phone
number.
2 Press to call.
VOICE Speak the name of the contact you want to call or the
voice command to control the phone functions.
( Make a call using voice recognition)
BATT LOW/ MID/ FULL * : Shows the strength of the battery.
NO SIGNAL/ LOW/ MID/ MAX * : Shows the strength of the current received
signal.
* Functionality depends on the type of the phone used.
Make a call using voice recognition
1
Press and hold to activate the voice recognition of
the connected phone.
2
Speak the name of the contact you want to call or the
voice command to control the phone functions.
• Supported Voice Recognition features vary for each phone.
Refer to the instruction manual of the connected phone for
details.
• This unit also supports the intelligent personal assistant
function of iPhone.
2
and until you finish entering the