Crivit SP-33 Manual Del Usario página 12

LED Rear light SP - 2
Safety information
• The LED rear light is not a substitute for the light equipment stipulated by the German
standard StVZO (§ 67).
• When used correctly, the LED rear light gives better visibility. The LED backlight
should not be used during rainy weather. It cannot be guaranteed to work if it gets
wet.
• Please only use the LED rear light together with this cycle helmet and always put it
onto the rotating wheel of the size-adjustment system.
• The LED rear light is only intended for personal use.
• Please make sure that, during use, the LED cannot be covered or obscured by collars,
rucksacks or movements of the head.
• The LED light can under certain circumstances come loose without this being noticed,
if it becomes caught on jackets, rucksacks or other objects.
• Please be aware that the battery of the LED light can fall out or become flat. Therefo-
re, check the light regularly for proper functioning.
• The batteries must not be exposed to excessive heat such as sunshine, fire or the like.
In the event that the batteries are
• incorrectly changed there exists the risk of explosion. Only replace the batteries with
the same or an equivalent battery type.
• Parents should ensure that their child also checks to make sure that the LED backlight
is working on a regular basis.
• The LED rear light is not suitable for use by children under 4 years of age.
• The LED rear light is not a toy and its use by children is only permitted if they are
under the supervision of adults.
• The changing of batteries must only be carried out by adults.
• If the battery leaks, avoid any contact with the skin as this can lead to skin irritation.
• Leaking batteries must be disposed of immediately
User information
1. Before the first use
• Take the tail light off the helmet (fig. J). Before the first use, remove the safety strips
from the reverse of the LED tail light. (Fig. I).
LED-REAR LIGHT SP-2
22
2. Removal and attachment of the tail light
• To remove the LED tail light, push this upwards out of the holder (Fig. J).
• To attach the LED tail light, push this again into the holder provided (Fig. J).
3. Functions
The LED rear light has three different functions, each of which can be used as desired (Fig.
K).
• Press x1: continuous light,
• press x2: flashing light,
• press x3: colour chaser,
• press x4: light off.
4. Changing the batteries
The LED tail light comes equipped with a CR 2025 (3V) battery.
• To change this battery, unscrew the four screws on the reverse of the light with a small
screwdriver.
• Then lift the cover, exchange the batteries and put the cover back on. Ensure that the
battery polarity is correct (Fig. L)
• Now fasten the cover again with the four screws (Fig. L).
Battery type: CR 2025 (3V)
5. Cleaning and care
The housing of the LED rear light can be cleaned with a damp cloth.
6. Disposal
Please do not dispose of flat batteries via the household waste, but instead use the collecting
container intended for this purpose.
LED Rear light SP - 2
23