Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Lamp adjustment
Inserting/Exchanging colour filtres
If you wish to use other colour-filtres, or if colour-filtres are to be exchanged, please follow the instructions
below:
Procedure:
Step 1:
Adjust the head of the device until the lens points away from the base.
Step 2:
Turn the colour-wheel until the desired colour-filtre appears and press carefully through the
colour-wheel from below to loosen the colour-filtre.
Step 3:
Use the other hand to pull out the colour-filtre from the colour-wheel.
Step 4:
Replace the desired colour-filtre in reversed order.
Slot-in system for exchanging colour-filters without tools!
Install the colour filtres with the device switched off only.
Unplug from mains before!
Do not operate this device with opened cover!
Inserting/Exchanging colour-filters as described above.
The lampholder is aligned at the factory. Due to
differences between lamps, fine adjustment
may improve light performance.
Strike the lamp, open the shutter, set the
dimmer intensity onto 100 % and direct the light
towards a flat surface (wall). Center the hot-
spot (the brightest part of the beam) using the 3
adjustment screws „1, 2, 3" Turn one screw at
a time to drag the hot-spot diagonally across
the projected image. If you cannot detect a hot-
spot, adjust the lamp until the light is even.
To reduce a hot-spot, pull the lamp in by turning
all three screws „1, 2, 3" clockwise ¼-turn at a
time until the light is evenly distributed.
If the light is brighter around the edge than it is
in the center, or if light output is low, the lamp is
too far back in the reflector. "Push" the lamp out
by
turning
counterclockwise ¼-turn at a time the light is
bright and evenly distributed.
DANGER!
Please note!
38/110
the
screws
„1,
00031483.DOC, Version 1.0
2,
3"
Publicidad
Tabla de contenido
