Important Setting For The Surveillance Set Ioz - Monacor IOR-204 Manual De Instrucciones

System General Configuration
Date 04/14/2018
Time 18:59:31
Date Format MM/ DD/YY
Time Format 24Hour
Language ENGLISH
Video Format PAL
Menu Timeouts 30s
Don't show this window next time.
Fig. 7-19 Basic system settings
Menu item Note
Date Always make sure to update the date and the
time so that it will be possible to search record-
Time
ings in specific time ranges.
Date Format Format of the date
Time Format 24-hour format or 12-hour format
Language To select the menu language
Colour format for analog cameras only
Video Format
(not relevant)
When there is no user input or user action, the
menu will automatically disappear after
Menu Timeout
30 seconds, 1, 2, 5 or 10 minutes
OFF = The menu will be shown until it is exited.
8) When the settings have been made, click the field "Don't
show this window next time" in the lower left corner of
the menu to make sure that the wizard will not be called
up with the next switch-on. Then click "Save" to save the
settings.
9) When the date or the time have been changed, the fol-
lowing warning will appear:
Warning!
System time will be changed, it may cause
recording video list messed up and recording video
loss, continue?
OK Cancel
Fig. 7-20 Warning:
The system time has been changed; this may corrupt the
list of recordings and recordings may get lost.
Click "OK" to confirm. The message "Wizard Complete!"
will appear. Click "OK" to confirm.
Wizard Complete !
OK
Fig. 7-21 Message "Wizard Complete!"
10) The most important settings for operating the recorder
have now been made. However, if it is possible to access
the recorder via the Internet, make sure to enable the pass-
word protection feature and to change the password (see
chapter 7.7).
11) Finally, reboot the recorder so that all changes will take
effect (Main Menu  Shutdown  Reboot).
3 0
×
Cancel Previous Save
7.5 Important setting
for the surveillance set IOZ-...
The sets IOZ-204BV, IOZ-204DV and
IOZ-408BV, IOZ-208DV
are preconfigured in such a way that the cameras provided
will be automatically linked to the recorder as soon as they are
connected to the jacks LAN ... (5 and 6). With this preconfig-
uration and when the cameras have been connected to the
jacks LAN ..., the recorder will try to automatically establish
links to other network-capable units which may result in an
incorrect operational state. Therefore, always make sure to
change the network setting:
1) To show the toolbar, press the right mouse button or move
the mouse pointer to the centre of the lower edge of the
screen.
2) Click the icon Main Menu.
3) The menu "Parameter" is selected. Select the submenu
"Network" and then click the section "Switch".
Parameter Record Search
Display
IP Adresse 010.010.025.100
Record Subnet Maske 255.255.000.000
Gateway 010.010.000.001
Capture
Switch Mode Auto Mode
Network
Network
Switch
Email
Email Schedule
DDNS
RTSP
Alarm
Fig. 7-22 Changing the setting "Switch Mode" to "Manual Mode"
4) In the line "Switch Mode", change the setting from "Auto
Mode" to "Manual Mode"
5) Click "Save" to save the settings.
6) The message "Save Parameters Successful" will appear.
Click "OK" to confirm.
7) To exit the menu, click "Cancel".
i
Device System Advanced
Default Save
i
Shutdown
Cancel
41