CELME FAMILY 220 CE Manual De Instalación página 11

6.1.2 SHARPENING WITH MOD FA (WITH FIXED SHARPENER)
BEFORE SHARPENING THE BLADE, CLEAN THE MACHINE AND DEGREASE THE BLADE
ACCURATELY.
1. PLUG THE MACHINE
2. LIFT THE SHARPENER AND TURN IT BY 180° TO TAKE THE BLADE BETWEEN THE TWO
GRINDING WHEELS. (Fig.11)
3. KEEP BUTTON "A" PRESSED FOR 5/10 SECONDS TO SHARPEN.
4. KEEP BUTTON "B" PRESSED FOR A FEW SECONDS TO DEBURR.
5. STOP THE MACHINE AND RETURN THE SHRPENER IN ITS INITIAL POSITION. (Fig.12-13)
WARNING
:USE BUTTON "A" TO SHARPEN, AND BUTTON "B" TO DEBURR THE CUTTING
EDGE.
DURING THE SHARPENING PROCESS, KEEP TO THE ORIGINAL DRAWING OF THE
BLADE BEVEL. REPLACE THE BLADE WHEN THE CLEARANCE BETWEEN THE RING AND
BLADE EXCEEDS 6 MMS.
6.2 LUBRICATION
PERIODICALLY LUBRICATE THE SLIDING ELEMENTS WITH WHITE VASELINE OIL.
FOR NOT DAMAGING THE SLICER, NEVER USE SEED OIL OR OLIVE-OIL. LUBRICATE ALL
ELEMENTS USING THE OILERS AS SHOWN IN FIGURE 15-16.
6.3 MACHINE IDLE FOR A LONG TIME
SHOULD THE MACHINE BE IDLE FOR A LONG TIME, DISCONNECT THE WALL MAIN SWITCH AND
CLEAN THE MACHINE AND ITS ACCESSORIES ACCURATELY.
USE WHITE VASELINE OIL (OR SIMILAR PRODUCTS) TO PROTECT ALL THE MACHINE
ELEMENTS. WE ADVISE COVERING THE MACHINE WITH A NYLON (OR SIMILAR) CLOTH.
11