Conceptronic CBGIGA24 Manual Del Usuario página 8

ENGLISH
5.1 PC to Switch
A PC can be directly connected to the switch, giving the PC a high-bandwidth dedicated connection to the
network. The PC must first be fitted with a 10BASE-T Ethernet, 100 BASE-TX Fast Ethernet or 10/100
dual-speed network interface card (NIC) with an RJ-45 jack for twisted-pair connections.
In the case of 10BASE-T, the PC can be connected using a Category 3, 4 or 5 UTP/STP straight cable; a
10/100 dual-speed or 100BASE-TX connection needs Category 5 or better UTP/STP.
The PC can be connected to any of the sixteen ports (labeled 1 - 16).
The LED indicators for PC connections are dependent on the LAN card (NIC) capabilities. If no LED
indicators are illuminated after connecting the cable, check the PC's LAN card, the cable, switch
conditions and connections.
5.2 Switch to Switch (or other devices)
The CBGIGA24 can be connected to another switch or other devices (routers, bridges, etc.) via a two-pair
Category 3, 4, 5 UTP/STP straight or crossover cable.
When connecting the CBGIGA24 to a 10 Mbps (only) Ethernet device, a Category 3, 4 or 5 UTP/STP cable
can be used; a connection to a 10/100 dual-speed or 100 Mbps Fast Ethernet device needs to use Category
5 or better UTP/STP.
Note : A straight-through cable is always used when connecting an MDI-X port to an MDI-II port.
A crossover cable must be used whenever connecting an MDI-II port to an MDI-II port or when
connecting an MDI-X port to an MDI-X port.
Your Gigabit Ethernet Switch is now ready to use!
5. Connecting the switch
8