Descargar Imprimir esta página

HQ-Power HQMC10050 Manual Del Usuario página 4

Ocultar thumbs Ver también para HQMC10050:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
Always make sure to connect the device to an alternating current matching the
value stated on the device.
Always install the device in a well-ventilated location.
Keep this device away from dust and extreme temperatures. Make sure the
ventilation openings are clear at all times. For sufficient air circulation, leave at least
2.5 cm in front of the openings.
Never connect the device to a dimmer or rheostat.
In the event of an operating problem, stop using the device immediately.
Never try to repair the device. There are no user-serviceable parts inside the device.
Refer to an authorized dealer for service and/or spare parts.
This device is not designed for permanent operation: regular operation breaks will
prolong its live.
3.
General Guidelines
Refer to the Velleman
manual.
All modifications of the device are forbidden for safety reasons. Damage caused by
user modifications to the device is not covered by the warranty.
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising
from the possession, use or failure of this product.
Keep this manual for future reference.
4.
Installation and Connection
Install the device on an even, fire-resistant, scratch-resistant, water-resistant and
non-slippery surface.
Make sure there is no flammable material within a 1 m radius of the device.
Install the device in a location with few passers-by that is inaccessible to
unauthorised persons.
Install the device in a location where you can easily access the power cord.
1.
Make sure the device is switched off.
2.
Connect the karaoke mixer to your TV set and sound system using the included
cables.
3.
Connect both microphones to the karaoke mixer.
4.
Connect the karaoke mixer to the mains using the included power supply.
5.
Turn both microphone volume controls to their minimum position. Switch on the
karaoke mixer, your TV set and sound system.
6.
Adjust the tone, echo and volume to the desired level. The karaoke system is
ready-for-use.
7.
Switch off and disconnect from the mains after use.
V. 02 – 04/09/2018
HQMC10050
®
Service and Quality Warranty on the last pages of this
4
©Velleman nv

Publicidad

loading