Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions and Parts List
! IMPORTANT !
This pressure washer is equipped
with a microswitch sensitive to water
flow. This Instant Start/Stop switch
(ISS) senses water flow in the pump.
When the trigger is released, water
stops flowing through the pump.
The ISS then automatically turns the
motor off to protect pump from
overheating.
OPERATION
1. Pull trigger on gun.
2. Turn the "ON/OFF" switch to
"ON".
3. Release trigger. The pressure
washer motor will stop running.
4. To spray again, pull trigger and
motor and pump will restart.
Note: Occasionally the motor may
run for a short time to bring fresh,
cool water into the pump even
if trigger is released. This is part
of normal operation and will not
damage the unit.
switch to "OFF" then trigger gun
to release hose pressure before
unplugging power cord.
damage. Always make sure the
"ON/OFF" switch on the unit is
"OFF" and unit is unplugged prior
to storage.
will start spraying when trigger
is squeezed if ON/OFF switch is in
"ON" position. Always point gun in
safe direction.
Call 1-800-330-0712
for Technical Service
www.chpower.com
Always turn
the "ON/OFF"
Risk of
equipment
Risk of
Injection. Unit
Important Safety
Instructions
SAvE ThESE INSTRucTIONS
When using this product, basic
precautions should always be followed,
including the following:
1.
Read all instructions before using
the product.
2.
ALWAYS disconnect power before
disassembling or repairing the unit.
3.
Follow all safety codes as well as the
Occupational Safety and Health Act
(OSHA).
4.
Ensure safety devices are operating
properly before each use. DO NOT
remove or modify any part of the
gun or unit.
5.
Know how to stop this product
and bleed pressure quickly. Be
thoroughly familiar with the
controls.
6.
Stay alert – watch what you are
doing.
7.
Do not operate the product when
fatigued or under the influence of
alcohol or drugs.
8.
Keep operation area clear of all
persons.
9.
Do not overreach or stand on
unstable support. Keep good
footing and balance at all times.
10. Follow the maintenance instructions
specified in the manual.
11. This product is provided with a
ground fault circuit interrupter,
GFCI, be sure to inspect cord and
GFCI prior to use. Any repair or
replacement of the power cord
must be performed by a qualified
(licensed or certified) electrical
technician.
12. NEVER use an extension cord with
this product.
2
PW1350
Publicidad
Tabla de contenido
