Zone 2 Remote Control - Yamaha RX-797 Manual De Instrucciones

Zone 2 remote control

This section describes the function of each button on the
Zone 2 remote control used to control Zone 2. You can
also use the Zone 2 remote control to control YAMAHA
CD players and YAMAHA cassette tape deck.
1
ZONE 2
CD PHONO
MD/TAPE VCR
2
DVD
u
3
PRESET
d
A/B/C/D/E
4
A/B
5
w e
DIR A
b s
ID1 ID2
6
(Europe model)
1 Infrared signal transmitter
Sends infrared signals.
2 Input selector buttons
Select the desired input source of Zone 2.
POWER
7
STANDBY
TUNER
8
DTV/CBL
+
9
VOLUME
–
0
MUTE
DISPLAY
f
DIR B REC
DISC
a
CD TAPE
A
p
3 PRESET u / d
Selects the preset station number (1 to 8) when TUNER is
selected as the input source.
4 A/B/C/D/E
Selects the preset station group (A to E) when TUNER is
selected as the input source.
5 CD/TAPE control buttons
Controls YAMAHA CD players or YAMAHA cassette
tape deck.
6 ID1/ID2 switch
Switches the remote control ID between ID1 and ID2 (see
page 30).
7 POWER
Turns on Zone 2.
8 STANDBY
Sets Zone 2 to the standby mode.
9 VOLUME +/–
Increases or decreases the sound output level of Zone 2.
Note
This does not affect the OUT (REC) level.
0 MUTE
Mutes the sound output to Zone 2. Press again to restore
the sound output to the previous volume level.
A CD/TAPE switch
Switches the function of the control buttons numbered 5
between controlling YAMAHA CD players and
controlling YAMAHA cassette tape deck.
CONTROLS AND FUNCTIONS
9