Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
ASSEMBLING THE LEG STAND
See Figures 7 - 10.
NOTE: Do not use this leg stand with other equipment or
for other purposes.
Position the inner and outer support brackets as shown
below so they resemble an "X". Align the holes for hard-
ware.
Insert a hex head bolt through a large washer, then
through the outer support bracket, a second large washer,
the inner support bracket, and a third large washer. Install
a large nut and tighten securely, but do not overtighten.
Repeat the process on the opposite side.
Slide the stand legs into the support brackets. Align the
holes for hardware.
NOTE: The longer side of the stand legs should face out.
INNER
SUPPORT BRACKET
LARGE
WASHER
HEX HEAD
BOLT
OUTER
SUPPORT BRACKET
LARGE
NUT
LARGE
WASHERS
Using the socket head bolts, small washers and small
nuts, secure the stand legs to the support brackets as
shown. Tighten securely.
NOTE: Once the legs are installed, try to fold the stand.
If the stand will not fold, adjust the tightness of the nuts
securing the support brackets as needed just until the
stand can fold without binding.
INNER SUPPORT BRACKET
ANGLED ENDS
WITH WIDER SIDE
FACING OUT
Fig. 7
SMALL
Fig. 8
16 − English
NUT
SMALL
WASHERS
STAND
LEGS
Fig. 9
SOCKET
HEAD BOLTS
Fig. 10
Publicidad
Capítulos
