Using Channel Scan; Programming Favorite Channel Scan; Re-Assigning Device Keys - One for All URC10820N Guia Del Usuario

Using Channel Scan

In the TV, VCR, DVD, CBL and SAT modes, use the FAV key to
start a 3-second scan of all favorite channels (if programmed,
"Programming Favorite Channel Scan") and/or all channels for the
selected mode.
Press TV, VCR, DVD, CBL or SAT once.
1.
Press FAV once.
2.
• If Favorite Channel Scan has been set up, scanning of favorite
channels will start and cycle through stored channels, then
proceed to the next channel up and cycle through all channels
on the selected device.
• If Favorite Channel Scan has not been set up, scanning will start
with the current channel, then proceed to the next channel up
and cycle through all channels on the selected device.
3. To stop scanning channels at any time, press any key once.

Programming Favorite Channel Scan

In the TV, VCR, DVD, CBL and SAT modes, you can store a list of
up to 10 favorite channels, in any order, that will be immediately
scanned when you press FAV (see "Using Channel Scan").
NOTE: Only channels of one mode can be stored for Favorite
Channel Scan.
On the remote control, press TV, VCR, DVD, CBL or SAT once.
1.
2. Press and hold SET until the LED (red light) blinks twice, then
release SET.
3. Enter 9 9 6. The LED will blink twice.
4. Use the keypad to enter a favorite channel number (e.g., 031).
Then press SET once.
NOTE: If the original remote control required pressing an
ENTER key to change the channel, also press the ENTER key
after the channel number (e.g., 0 3 1 ENTER).
5. If desired, repeat step 4 (in this section) for each favorite
channel to be stored, up to a total of 10 channels.
NOTE: If you try entering more than 10 channels, the remote
control will automatically exit programming.
6. To exit programming, press and hold SET for 3 seconds. The
LED will blink twice.

Re-Assigning Device Keys

You can set this remote to control a second TV, VCR, DVD player,
or other device. For example, to control a TV, a cable box, and two
DVDs, you will need to re-assign the unused AUX1 key to operate
the second DVD as follows:
1. On the remote control, press and hold SET until the LED (red
light) blinks twice, then release SET.
Enter 9 9 2. The LED will blink twice.
2.
Press DVD once, then press AUX1 once.
3.
4. The AUX1 key is now ready to be programmed for your second
DVD. See "Setting Up Your Components."
To re-assign other device keys to the AUX1 key, repeat steps 1
through 4 by substituting the sequence from the following chart:
To Re-Assign Device
AUX1 as 2nd TV key:
AUX1 as 2nd VCR key:
12
Perform Sequence
SET - 9 - 9 - 2 - TV - AUX1
SET - 9 - 9 - 2 - VCR - AUX1