Transport Key Punch-Through; Channel Lock; Code Retrieval - One for All OARN08G Guia Del Usuario

All manuals and user guides at all-guides.com

Transport Key Punch-Through

Transport Key Punch Through allows the transport keys
(REVERSE, PLAY, FORWARD, RECORD, STOP, PAUSE, SKIP FWD,
SKIP BACK, and SLOW), when pressed in TV, SAT, CABLE and
mode, whichever was accessed last. Transport Key Punch-Through
occurs automatically and allows you to use the transport keys
without exiting the current mode. For example, if the transport
keys were last used in DVD mode and accessed again after
pressing the TV key, they will punch through to the DVD. The
default Transport Key Punch Through is set to DVD for TV, SAT,
CABLE and AUDIO.
Note: Transport Key Punch Through does not occur in cases

Channel Lock

Channel lock automatically sends channel commands, like the
CH, LAST, and 0–9 number keys, to your satellite receiver, cable
box, or digital TV converter when you're in TV mode. This can
save you keypresses if you use a device other than your TV to
change channels.
To turn channel lock on:
1. Press and hold the device key for the device you use to
change channels. While you're holding down this device
key, use your other hand to press and hold the remote's CH
up key at the same time.
2. Wait until the remote's POWER key comes on and stays on.
Then release both keys.
3. Press ENTER to lock channel commands to this device.
To turn channel lock off:
1. Press and hold the TV key. While you're holding down the
TV key, use your other hand to press and hold the remote's
CH down key at the same time.
2. Wait until the remote's POWER key comes on and stays on.
Then release both keys.
3. Press ENTER to start changing channels with your TV.

Code Retrieval

Once you've programmed the remote to control your devices, you
may want to record the codes for future reference. If you used
the Direct Code Entry method, this is easy. Just find the codes you
entered and make a note of them in the boxes below. If you used
one of the Code Search methods to program your remote or if
you used the Direct Entry method but don't remember the code,
you will need to retrieve each device's five-digit code. Retrieving
the actual code and writing it down will save you time if you ever
need to program the remote again. If the codes are recorded, you
can use the Direct Entry method to reprogram your remote to
control your devices, which is quick and easy.
TIPS:
11