Husqvarna H342SL Manual Del Dueño página 6

3
CONTAINER MOUNTING (See Fig. 3)
1. Install one container to left side first. Install another
container to center position and one in right position.
NOTE: Left edge of right container should always overlap
right edge of left container at center supports.
2. Close cover and lock latches over center support tubes.
To lock and release latches, pull back on latch handles.
COVER LATCH
HANDLES
CENTER
SUPPORT
TUBES
CONTAINER
HANDLE
DEFLECTOR SHIELD
REAR LATCH
Fig. 3
4
LOWER CHUTE - MOWER WITH
MOUNTING TAB (See Fig. 4)
1. Raise and hold deflector shield in upright position.
2. Place slot in lower chute over mounting tab on mower
and position lower chute over mower opening as shown.
3. Hook rear latch into flange hole on back of mower.
4. Hook front latch into flange hole on front of mower.
CAUTION: Do not remove deflector shield
from mower. Raise and hold shield when
attaching lower chute and allow it to rest
on chute while in operation.
Fig. 4
6
DEFLECTOR SHIELD
HINGE BRACKET
MOUNTING
TAB
FRONT LATCH