Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
MOTOREDUCTOR PARA CANCELAS CORREDIZAS
67411230
®
MERCURY
MOTORIDUTTORE PER CANCELLI SCORREVOLI
MOTOR REDUCER FOR SLIDING GATES
MOTEUR POUR PORTAILS COULISSANTS
ANTRIEB FUER SCHIEBETORE
Zona industriale 64020 S.ATTO Teramo - (ITALY)
Tel. +39 (0)861 588341 r.a. Fax +39 (0)861 588344
www.seateam.com
seacom@seateam.com
REV 04 - 07/2016
SEA S.p.A.
Italiano
English
Français
Español
Deutsch
Publicidad
Manuales relacionados para SEA MERCURY Serie
Resumen de contenidos para SEA MERCURY Serie
- Página 1 MOTORIDUTTORE PER CANCELLI SCORREVOLI MOTOR REDUCER FOR SLIDING GATES MOTEUR POUR PORTAILS COULISSANTS MOTOREDUCTOR PARA CANCELAS CORREDIZAS ANTRIEB FUER SCHIEBETORE SEA S.p.A. Zona industriale 64020 S.ATTO Teramo - (ITALY) Tel. +39 (0)861 588341 r.a. Fax +39 (0)861 588344 www.seateam.com seacom@seateam.com...
-
Página 2: Main Parts
® MERCURY Sistemi Elettronici di Apertura Porte e Cancelli INSTALLATION AND CONNECTION INSTRUCTIONS International registered trademark n. 804888 ENGLISH MERCURY is a sliding gate motor with grease lubricated TECHNICAL DATA 400 - 110V 600 - 110V 400 24V-110V 600 24V-110V gear. - Página 3 ® Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 ENGLISH Fig. 2 DIMENSIONS (mm) Plinth 3 0 0 ONLY 230V VERSION DIMENSIONS (mm) 2.2. Before cementing the plate insert a flexible plastic duct of at least 30mm in diameter into the special hole of the plate. 1.
- Página 4 ® Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 ENGLISH 4.2. Fix the motor on the foundation plate with the 2 included 5.3. Lean the gear rack element on the toothed pinion of the nuts, adjusting the side position (Fig. 6) so to respect the shown motor in parallel to the ground slideway of the gate, as shown in quota in (Fig.
-
Página 5: Limit Switch Adjustment
® Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 ENGLISH 6. LIMIT SWITCH ADJUSTMENT 7. MAGNETIC LIMIT SWITCH 6.1. To install and adjust the limit switches in opening procede as follows (Fig. 12): - Completely open the gate. - Place the plate on the rack in order to have the lever of the Steel rack mechanical limit switch (Fig. - Página 6 Fig. 20 Fig. 22 NOTICE SEA S.p.A. can not be deemed responsible for any damage or accident caused by product breaking, being damages or accidents due to a failure to comply with the instructions herein. The guarantee will be void and the manufacturer responsibility (according to Machine Law) will be nullified if SEA Srl original spare parts are not being used.
- Página 7 Don’t waste product packing materials and/or circuits. When being transported this product must be properly packaged and handled with care. SEA reserves the right to do changes or variations that may be necessary to its products with no obligation to notice. 67411230...
- Página 8 SEA. 4) PAGAMENTI Le forme di pagamento ammesse sono quelle comunicate o accettate di volta in volta dalla SEA. Il tasso di interesse sul ritardo da pagamento è del 1,5% mensile e comunque non oltre il tasso massimo legalmente consentito.
- Página 9 The recognized defects, whatever their nature, shall not produce any responsibility and/or damage claim on the part of the Buyer against SEA. The guarantee is in no case recognized if changes are made to the goods, or in the case of improper use, or in the case of tampering or improper assembly, or if the label affixed by the manufacturer has been removed including the SEA registered trademark No.
- Página 10 14. Transit through the leaves is allowed only when the gate is fully open. 15. The User must not attempt to repair or to take direct action on the system and must solely contact qualified SEA personnel or SEA service centers. User can apply only the manual function of emergency.
- Página 11 3. Este producto fue diseñado y construido exclusivamente para el uso especificado en esta documentación. Cualquier otro uso no expresamente indicado puede afectar la integridad del producto y ser una fuente de peligro. El uso inadecuado es también causa de anulación de la garantía. SEA S.p.A. se exime de toda responsabilidad causadas por uso inapropiado o diferente de aquel para el que el sistema automatizado fue producido.
- Página 12 International registered trademark n. 804888 Dichiarazione di conformità Declaration of Conformity La SEA S.p.A. dichiara che, con l’installazione degli adeguati dispositivi di sicurezza e di filtraggio disturbi, i prodotti: SEA S.p.A. declares that by installing the appropriate safety equipment and noise filtering the...
- Página 13 ® Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 Note - Notes - Note - Notas - Anmerkung...
- Página 14 è stato testato singolarmente al fine di garantire i più alti livelli qualitativi e la vostra soddisfazione. Vi ringraziamo per aver scelto SEA. This item has been produced following strict production procedures and has been singularly tested for the highest quality levels and for your complete satisfaction.
- Página 15 N.B: L’estensione della garanzia legale di 12 mesi a 24 mesi e 36 mesi è va- lida solo se il presente modulo viene rispedito per posta o fax a SEA S.p.A. entro 15gg dalla data di acquisto. Allegare relativa fattura d’acquisto.
- Página 16 ® Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 SEA S.p.A. Zona industriale 64020 S.ATTO Teramo - (ITALY) Tel. +39 (0)861 588341 r.a. Fax +39 (0)861 588344 www.seateam.com seacom@seateam.com...