SEA SATURN 600 Manual Del Usuario página 7

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
10. SCREW COVER MOUNTING
At the end of the mechanical installation and after having
executed all the required adjustments, mount the two screw
covers on the operator as shown in Fig. 24.
Fig. 24
11. ELECTRIC CONNECTIONS OF THE
INSTALLATION (Fig. 25)
The cable mesures are indicated in mm
1
2
1) Saturn - Boxer
2) Photocell Sx
3) Photocell Dx
4) Mechanical safety edge
5) Key push botton
Ex. 230V version with integrated electronic control unit
14
®
2
8
6
4
5
3
6) Flasher
7) Receiver
8) Warning notice
9) Junction box
10) Differential 16A - 30mA
12. RISK EXAMINATION
The points pointed by arrows in Fig. 26 are potentially
dangerous. The installer must take a thorough risk examination
to prevent crushing, conveying, cutting, grappling, trapping so
as to guarantee a safe installation for people, things and animals
(Re. Laws in force in the country where the installation has been
made.)
13. NOTICE
SEA can not be deemed responsible for any damage or accident
caused by product breaking, being damages or accidents due to
a failure to comply with the instructions herein. The guarantee
will be void and the manufacturer responsibility (according to
Machine Law) will be nullified if SEA original spare parts are not
Fig. 25
being used.
The electrical installation shall be carried out by a professional
technician who will release documentation as requested by the
laws in force.
DIRECTIONS that the installer must read carefully before
installing. Packaging materials such as plastic bags, foam
7
polystyrene, nails etc must be kept out of children's reach as
dangers may arise.
9
14. SAFETY PRECAUTIONS:
All electrical work and the choice of the operating logic should
conform to current regulations. A 16 A 0,030 A differential
switch must be incorporated into the source of the operators
10
main electrical supply and the entire system properly earth
bonded. Always run mains carrying cables in separate ducts to
low voltage control cables to prevent mains interference.
15. SPARE PARTS:
To obtain spare parts contact:
SEA S.p.A. -Zona Ind.le, 64020 S. ATTO Teramo Italia
This is a quotation from the GENERAL
ENGLISH
Fig. 26