SEVERIN Mr. Twister KM 3923 Instrucciones De Uso página 14

Spiral attachment
∙ Caution: Please take careful note of the diagrams at the
beginning of the manual before operating the appliance.
∙ Clean the food and cut it into pieces no longer than 15
cm.
∙ Tip: Always cut the food in such a way that
there is a fl at surface to attach to the food
holder on the spiral attachment pestle.
∙ Fit the collection container into the appliance.
∙ Fit the gear-wheel insert into the housing.
∙ Select the desired blade insert and fi t it into the gear-
wheel insert.
∙ Fit the spiral attachment and turn clockwise until it is
heard locking into place ( ).
∙ Take a prepared food item and attach its fl at surface to
the end of the pestle (diagrams I & II).
∙ Insert the pestle with the food into the feeder chute.
Always hold the food fi rmly in place until it actually
touches the blade insert (diagram III).
∙ Turn the appliance on and guide the pestle slowly
downwards, without applying much pressure (diagram
IV).
∙ Tip: Should a piece of food become separated
from the pestle, switch the appliance off and
disconnect it from the mains. Then take off the
spiral attachment, remove the detached food and
re-attach it to the pestle.
∙ The processed food is collected inside the container.
∙ Take out the pestle and attach a new piece of food, if
desired.
∙ For technical reasons, a small piece if food will remain on
the pestle. Remove this and use it another time.
∙ Tip: For best results the blade insert should be
cleaned between cycles, but at least each time the
appliance is switched off.
∙ Switch the appliance off and disconnect it from the mains.
Cutting attachment
∙ Clean the food.
∙ Fit the collection container into the appliance.
∙ Fit the gear-wheel insert into the housing.
∙ Select one of the blade inserts
gear-wheel insert.
∙ Fit the cutting attachment so that the feeder tube points
towards the front, and secure it by turning clockwise ( )
until it is heard locking into place.
∙ Put one or more of the prepared food items into the
feeder tube. The tube can be fi lled completely.
∙ Turn the appliance on and guide the cutting attachment
pestle slowly downwards, without applying much
pressure. Make sure that the ridge on the pestle fi ts into
the guide groove in the feeder tube.
∙ The processed food is collected inside the container.
14
- and fi t it into the
∙ Take out the pestle and, if required, put in more food.
∙ Switch the appliance off and disconnect it from the mains.
∙ Tip: For best results the blade insert should be
cleaned between cycles, but at least each time the
appliance is switched off.
After use
∙ The appliance should be thoroughly cleaned after each
use (see Cleaning and care).
∙ Empty the container.
∙ Take out the pestle.
∙ Remove the attachment by turning anti-clockwise (
∙ Remove the blade and gear-wheel inserts.
Recipes
In the mood for some healthy recipe ideas?
or try www.severin.com/service/recipes
Cleaning and care
∙ Always disconnect the appliance from the mains before
cleaning.
∙ Do not use abrasives, harsh cleaning solutions or hard
brushes for cleaning.
∙ To avoid the risk of electric shock, do not clean the
housing with liquids and do not immerse it.
∙ The housing may be wiped with a slightly damp, lint-free
cloth.
∙ All detachable parts (see After use) may be cleaned
using hot water and a mild detergent, or in a dishwasher.
∙ Caution: The blades are very sharp. Always use the
cleaning brush provided.
Disposal
Devices marked with this symbol must be
disposed of separately from your household
waste, as they contain valuable materials which
can be recycled. Proper disposal protects the
environment and human health. Your local authority or
retailer can provide information on the matter.
).