Hdmi Out Connection - NAD T 557 Manual Del Usuario

OPERATION
uSing the t 557
reSolution
The T 557 provides several video output resolutions for the HDMI OUT
and COMPONENT VIDEO OUT jacks. Resolution can be changed via the
"Resolution" option in the DISPLAY SETUP menu or by toggling the [RES]
button of the BR 2 remote control. The T 557 must be at STOP mode when
BR 2's [RES] button is used to change the RESOLUTION setting.
The following resolutions are selectable or available
auto: If the HDMI OUT jack is connected to a TV that provides display
information, the T 557 automatically selects the resolution best suited
to the connected TV. If COMPONENT VIDEO OUT is the selected video
output media, the resolution changes to "Auto" – the default resolution
for Component Video OUT.
1080p: Outputs 1080 lines of progressive video (applicable only for
HDMI connection).
1080i: Outputs 1080 lines of interlaced video.
720p: Outputs 720 lines of progressive video.
480p/576p: Outputs 480/576 lines progressive video.
480i/576i: Outputs 480/576 lines of interlaced video.
Available resolution varies according to connection and media format.

hdmi out connection

• For the 480i/576i resolution setting, the output resolution of HDMI OUT
will change to 480p/576p.
• If you select a resolution manually and then connect the HDMI
jack to TV and your TV does not accept it, the resolution setting will
automatically be set to "Auto".
• The 1080p video output frame rate may be automatically set to either
24Hz or 50/60Hz depending upon the capability and preference of the
connected TV and based on the native video frame rate of the BD-ROM
disc's contents.
• If you select a resolution that is not compatible with your TV, a warning
message as shown below will appear.
12
T557_eng_OM_v05.indd 12
After resolution change, if you cannot see the screen, please wait for about
20 seconds and the resolution will automatically revert back to the previous
resolution or a message screen as below may appear
Select "Yes" for the current resolution setting (the VFD will show the
current resolution setting) to be applied. "Current" resolution setting is the
suggested new resolution setting.
Select "No" to seek for the next applicable resolution setting. The above
"Warning" screens will interchangeably be displayed until you select "Yes" to
a suggested resolution setting.
10/08/2009 9:39pm